Gyproc Plasterboard Patches various sizes 12 Pack (2 x 50mm, 5 x 100mm & 5 x 150mm))

Product Information

Some products may be delivered straight to your door from one of our suppliers and these products will be labelled within the product description. With the batten positioned screw it in place through the front of the plasterboard making sure the screw heads go below the skim of plaster on the board. Do this with both battens and then cut a square of plasterboard to fit in the hole. This can be screwed to the battens with drywall screws and the square plastered together with the 4 screw holes for the battens. Remove any loose bits from the edge of the hole or damaged area, and sand this down. Remember to always wear eye protection when sanding.

Cut a piece of plasterboard that is slightly narrower than the hole but an inch or so longer top and bottom. Screw in a long screw in the middle of the patch; this will be used to position the patch in place.

Explore more

Once dry, you can gently rub down the plaster or filler, and then paint the repaired area to match the surrounding wall. How to Fill Large Holes in Plasterboard

A range of images, videos and case studies to inspire functional spaces for living, work and leisure. The final stage to this repair is to fill the hole with a suitable filler such as Polyfilla or the like. Once mixed (or the tub is open if you have a pre-mixed version), scoop out a lump using a small trowel and apply it to the hole, using the trowel to completely fill the area of the hole by pushing into the corners. Artex Caulker (250mm ) helps to fill joints and create smooth finishes or any suitable jointing knife. The two main repair methods can be found below: Repairing a Plasterboard Hole Using a Piece of Plasterboard or Timber Another way to fill a hole in plasterboard is to enlarge the hole first to make a square of a suitable size. Then cut two battens (19 x 38mm timber will suffice) and make sure they are 100mm longer than the size of the square you have cut.Lighting Sofa In A Box Bathroom Lights Mirrors Carpets Outdoor Lighting Radiator Covers Fireplaces & Stoves Apply the filler by working it into the holes of the patch and towards the edge. Feather out at least 50mm beyond the edges of the patch to create a smooth, seamless finish. Leave to set for a minimum 30 minutes.

Once the adhesive has dried enough to support the patch you can now push the screw out into the wall void. Leave for a further 24 hours for the adhesive to completely harden off and then you can start filling. Feed a batten into the hole and twist it so it is either upright or horizontal and one third of the distance either up or down or across the hole. Make sure you have a 50mm overhang either side of the hole.Gyproc EasiFill 20 has a working time of 20 minutes and the second coat can be applied after 40 minutes. Gyproc EasiFill 45 has a working time of 45 minutes and the second coat can be applied after 80 minutes.

Finally, always follow the paint manufacturer’s recommendation, apply a primer or sealer before decorating. Spread a small blob over the hole and wait for it to dry. Once dry, get a 180-220 grit sandpaper and rub down until smooth and blended with the current surface. How do You Fix a Hole in Plasterboard on the Ceiling? When the plaster starts to dry, lightly scratch the surface with the end of the trowel in this pattern. Picture the scenario. You have a job list as long as your arm, but you’re seeking efficient solutions for your customers, saving you time but not cutting corners.Due to the nature of plasterboard and in a similar way hollow doors, they can become damaged quite easily. Once the first coat has set if you find any ridges, lumps, bumps or trowel marks, gently scrape these away using the edge of your filling knife, or leave to fully dry before sanding.